ROAD CLEANER RC-H2 - Oil spill removal - High pressure cleaner and vacuum cleaner

Price on request

Available immediately, delivery time: 3-4 weeks

Product number: ROAD CLEANER RC-H2

Product information "ROAD CLEANER RC-H2 - Oil spill removal - High pressure cleaner and vacuum cleaner"

The ROAD CLEANER RC-H2 is the professional solution for oil spill removal in vehicles with a power take-off (PTO) such as the VW Crafter, MAN TGE, Mercedes Sprinter, IVECO Daily or Renault Master. It is driven by the vehicle engine - no harmful exhaust fumes are produced, which enables safe operation in the load compartment.

Thanks to the simultaneous use of a high-pressure cleaner and vacuum cleaner, water consumption is reduced and cleaning is faster and more environmentally friendly. The extracted liquid is collected in a stainless steel tank. The system fulfils the requirements for ATEX-1 and ATEX-21 zones.

Technical features: Hydraulic requirement 15 l/min at 180 bar, high-performance cooling, emergency stop switch, operating hours counter, 300-litre water tank, 10 m suction hose and 40-litre collection tank with automatic shut-off.

You can find more information about the manufacturer here: FEP at KW Hydraulik.
Area of application: Hydraulics for commercial vehicles & vans up to 7.5 tonnes.

This model is for installation in vehicles with transmission power take-off (PTO).

VW CRAFTER / MAN TGE
MERCEDES SPRINTER
IVECO DAILY
RENAULT MASTER / OPEL MOVANO / NISSAN NV400

Driven by the vehicle engine, no harmful exhaust gases are produced at the unit, which enables safe operation in the load compartment.

With this drive variant, the high-pressure cleaner can be operated simultaneously with the vacuum cleaner.

This method requires less water, the work is faster and is more environmentally friendly.

The extracted liquid is collected in a stainless steel container.

The unit can be used in ATEX-1 and ATEX-21 hazardous areas.

Features

Hydraulics: 15 litres at 180 bar
Hydraulic system with high-performance cooling.
Thermal protection switch, oil level monitoring
Pressure gauge and pressure relief valve
Control unit with operating hours counter
Emergency stop switch (disconnects the system from the drive)
12 volt on-board voltage for system control
300 litre stainless steel water tank with water separator
Tank for cleaning additive 5 litres with proportion regulator
Brush for vacuum cleaner
Wash lance with high and low pressure nozzle
Hydraulic vacuum cleaner
Suction height 3 metres
Hose reel with spring return for suction hose, 10 metres, hose diameter 38 mm
40 litre tank for holding the oil-water mixture, switch-off when tank is full
Approval for ATEX-1 and ATEX-21 areas

Model ROAD CLEANER RC-H2C with additional gas-powered water heater.

Comparable tools